Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

impeller loose fit to shat with no setscrew or taper

Status
Not open for further replies.
electricpete

electricpete

Electrical
Joined
May 4, 2001
Messages
16,774
Location
US
Please see my thread on this subject on the pump forum (linked below) and provide any comments in that forum. Thanks.

thread407-142111

=====================================
Eng-tips forums: The best place on the web for engineering discussions.
 
Status
Not open for further replies.

Similar threads

A
  • Locked
  • Question Question
Vibration excitation with electromagnet
Replies
11
Views
6K
acoustic67
A
hawkish_man
  • Locked
  • Question Question
Can damping ratio be calculated without experiments or damping coefficient?
Replies
7
Views
2K
GVDR
G
Sparky4598
  • Question Question
Balancing large 8600hp electric motor with fluid film bearings
Replies
18
Views
9K
mfgenggear
mfgenggear
kingnero
  • Locked
  • Question Question
Welding on top of rail, to avoid noise in curves
Replies
4
Views
5K
kingnero
kingnero
271828
  • Locked
  • Question Question
Converting Spectrum to Lower Resolution
Replies
6
Views
5K
271828
271828

Part and Inventory Search

Sponsor

Back
Top