Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ignore invalid Mapkey sequences

  • Thread starter Thread starter Maike13
  • Start date Start date
M

Maike13

Guest
If I type in an invalid mapkey sequence, mapkeys stops working until I open and close the mapkey dialog box. Is there any trick to make mapkeys ignore invalid sequences? This is particularily annoying recently as we've just upraded to Creo 2.0 and many of the mapkeys we used to use have changed, so I'm always typing in the old mapkeys (now invalid) by mistake.
 
Just hit the backspace key to clear out the invalid characters.
 
Wow, that easy!! I guess I should have thought of that :-) Thank you so much for replying. It's been driving me nuts, and I probably never would have though of just backspacing.
 
Thanks dr_gallup for solution..
 

Part and Inventory Search

Sponsor

Back
Top