.iges import problem 2

[Ripper2009]

Hi all,
I have an .iges file, imported. When I want to make it into a part file, etc., instead og getting to choose from Part, assembly or drawing, I just get part. Below is the link to the file.
I cannot figure out what the problem is.

Thanks in advance...

http://www.savefile.com/files/1035040

Thanks,

Rip


SolidWorks 2007
SP 4.0

 

[CorBlimeyLimey]

That file is a bitmap image iges_crap.bmp

 

[handleman]

You can't import an IGES file to a drawing. If your IGES file has multiple bodies and you want it to open as an assembly, you need to open it through the SolidWorks File->Open dialog. When you change the file type to IGES the "References" button will change to "Options". Click it. Under the General category there is a checkbox labeled "Import multiple bodies as parts". If the IGES file contains multiple bodies, it will import each body as a separate part, and then put them all into an assembly for you. If that box is not checked, the bodies will all come in as one multibody part.

 

[Ripper2009]

Thanks all!

Blimey...how ya been?

Thanks,

Rip


SolidWorks 2007
SP 4.0