Overworked1
Mechanical
- Dec 7, 2006
- 33
Hello everyone,
I am trying to do what is probably a fairly simple equation, but I am not having much success. I have a piece of formed channel sheet steel, and I have a hole that is patterned in it. I want to put a If/Then that has three parameters in it that state if the overall length of the part is 120 or greater, then the pattern distance is 3. If the overall length of the part is 110 to 119, then the pattern distance is 2. And finally, if the overall length of the part is less than 110, then the pattern distance is 1.
Does anyone know if this can be done, and if so, what the equation might look like?
Aaron
SolidWorks/PDMWorks 08 4.0
CADKey 99 R1.0 (Yes, still using it!)
I am trying to do what is probably a fairly simple equation, but I am not having much success. I have a piece of formed channel sheet steel, and I have a hole that is patterned in it. I want to put a If/Then that has three parameters in it that state if the overall length of the part is 120 or greater, then the pattern distance is 3. If the overall length of the part is 110 to 119, then the pattern distance is 2. And finally, if the overall length of the part is less than 110, then the pattern distance is 1.
Does anyone know if this can be done, and if so, what the equation might look like?
Aaron
SolidWorks/PDMWorks 08 4.0
CADKey 99 R1.0 (Yes, still using it!)