Understanding the majority of the wiring conventions in most of the European prints I have come across, I have run across something I can not find information about. I am talking about a particular column (say column 2). Going into a 3 phase device the wires are labeled 221 222 223. On the load side they have 1221 1222 1223. I would have thought I should have seen 221 223 225 and on the load side 222 224 226. Can anyone direct me to some information where I can find out why the 1221 etc numbers or give me some feedback on them. Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
IEC Wiring Conventions
- Thread starter LRMesh
- Start date
RalphChristie
Electrical
Unfortunately I can give no code-reference, but I have seen it sometimes used if an additional part (meter, testblock, safety device, etc) is added afterwards - thus if the wiring is already numbered and connected, and an extra part is added.
Regards
Ralph
[red]Failure seldom stops us, it is the fear for failure that stops us - Jack Lemmon[/red]
Make the best use of Eng-Tips.com
Read the Site Policies at FAQ731-376
Regards
Ralph
[red]Failure seldom stops us, it is the fear for failure that stops us - Jack Lemmon[/red]
Make the best use of Eng-Tips.com
Read the Site Policies at FAQ731-376
- Status
Similar threads
- Locked
- Question
- Locked
- Question