Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Iassembly BOM

  • Thread starter Thread starter Jim Elfering
  • Start date Start date
J

Jim Elfering

Guest
We are using an Iassembly that includes two Iassemblies. We would like to produce a BOM that shows all the parts used in each sub Iassembly rather than just the two sub- Iassemblies. There is very little info about Iassembly BOMs.
 
In the BOM, make the subassemblies "Phantom". This will make the constituent parts visible in a structured BOM.
 
You must log in or register to reply here.

Similar threads

hititfaster
  • Locked
  • Question Question
BOM sort and renumber
Replies
3
Views
952
mcgyvr
mcgyvr
PriyankPadaria
  • Locked
  • Question Question
BOM (Bills of material) in inventor
Replies
2
Views
269
PriyankPadaria
PriyankPadaria
H
iassembly vs icopy cleanroom design
Replies
1
Views
5K
loworange88
L
automationbabe
  • Locked
  • Question Question
Custom iProperties in Drawing BOM
Replies
0
Views
145
automationbabe
automationbabe
oneilldm
  • Locked
  • Question Question
BOM Header Modifications?
Replies
6
Views
295
oneilldm
oneilldm

Part and Inventory Search

Sponsor

Back
Top