Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

I need to combine two sketches to produce my component.

Status
Not open for further replies.

barnsey1

Aerospace
Joined
Mar 21, 2012
Messages
6
Location
GB
Hi All,

I am new To NX so there could be a relatively easy solution to this, but I am struggling to Sweep the two profiles shown in the attachment,
Has anyone any advice how I could produce the two combined sketches.

I am currently using NX 6.0

Thanks in advance.
 
I assume that this is what you're looking for (see attached Part file). The operation that you were looking for, after creating the two solid bodies from the Sketches, can be found at...

Insert -> Combine Bodies -> Intersect...

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.
 
 http://files.engineering.com/getfile.aspx?folder=1c47d59e-f6ff-4f98-a867-c65fef419722&file=341237-JRB.prt
Thanks for your help John,

Big help that!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top