Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

I need HELP! with a DIN 5480 involute spline

Status
Not open for further replies.
vadacz

vadacz

Mechanical
Nov 3, 2014
1
Hello!
I want to calculate the distance between two pins (internal spline) NA68x3x21x7H. I should have measure it with D5.25 mm pins (it stands in the standard), but I have only D6 mm pins! So I need the distance (M2) between the two D6 mm pins.

Sorry for my english, I hope you understand me.
Thx
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Gage pins of this size are very cheap. So just spend a couple bucks to buy the correct size pins and do things right.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

C
  • Question
Help. Screw preload problem with sandwiched parts 1
Replies
9
Views
6K
desertfox
desertfox
R
  • Question
Looking for Help with Air Cylinder Selection for X-Z Slide Configuration 1
Replies
5
Views
3K
Stick.
Stick.
D
I need a Class 1 division 1 approved cable gland for both USA and Canada. And at the end of the cable there is a Molex connector.
Replies
0
Views
984
denuwan
D
T
  • Question
Designing a Cooling System with a Plate Heat Exchanger – Pump & Flow Control Advice Needed
Replies
2
Views
1K
thomx5
T
Helepolis
  • Question
Spring Modeling Help (Solidworks) 1
Replies
8
Views
376
ctopher
ctopher

Part and Inventory Search

Sponsor

Back
Top Bottom