Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
I-Deas .xpk
- Thread starter rothers
- Start date
Arkance/PhoeNX
Mechanical
NX1980 was the last release to allow import of xpk files. Since then you have to export JT from I-Deas to be able to open in NX.
- Thread starter
- #3
Not to hijack, but what file extensions did ideas use? I searched on .XPK and didn't find any.
We briefly had an Ideas user in the early 2000's when SDRC bought the old Camex Cammand software and we were upgraded to Ideas via Maintenance agreements at the time. Some of that tooling is still in use and record keeping from that era was lax. The Ideas user wasn't here very long and i'm sure most if not all the files were converted to CatiaV5 and once UGS took over Ideas, we let it expire.
We briefly had an Ideas user in the early 2000's when SDRC bought the old Camex Cammand software and we were upgraded to Ideas via Maintenance agreements at the time. Some of that tooling is still in use and record keeping from that era was lax. The Ideas user wasn't here very long and i'm sure most if not all the files were converted to CatiaV5 and once UGS took over Ideas, we let it expire.
- Thread starter
- #6
Similar threads
- Locked
- Question
