Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
I can't open catia part file
- Thread starter khaicva
- Start date
Run CATDUAV5 in batch mode if application level is OK. You can also clean first catsettings then try to open again.
Regards
Fernando
- Romania
- EU
Regards
Fernando
- Romania
- EU
Are you trying to open the part file in CATIA or insert it into a product?
Drew Mumaw
Drew Mumaw
Hi,
Please check if you have the license ( HD2 or MD2 ).If it is a higher version ( v5 r22,r23 etc.,) then convert it to the relevant version and try opening it.Also check for the date/time of the file and that of the system.Either one of them should work.
Please check if you have the license ( HD2 or MD2 ).If it is a higher version ( v5 r22,r23 etc.,) then convert it to the relevant version and try opening it.Also check for the date/time of the file and that of the system.Either one of them should work.
- Status
Similar threads
- Locked
- Question