Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

I am doing a freq-voltage conversio

Status
Not open for further replies.
01795584233

01795584233

Automotive
Joined
Nov 4, 2002
Messages
10
Location
DE
I am doing a freq-voltage conversion. But need to design a feedback element in the design loop(f/v converter)to control the frequency. Do u have any suggestion about that?. Is there any realisation software to check a digital output(after converting 0-10v to required digital signal through DAC).

Thanks
Senthil
 
Status
Not open for further replies.

Similar threads

CAD2015
  • Question Question
Capital Essentials 2408: How could I open in Capital Essentials a part direct from the Library folder?
Replies
1
Views
9K
CAD2015
CAD2015
VectorBear
  • Question Question
Most (all?) hybrids and BEVs have a 12V (or 16V) battery. Why?
2
Replies
29
Views
9K
3DDave
3DDave
fosrich
  • Locked
  • Question Question
SXL Primary Electrical Wire Ampacity
Replies
1
Views
969
TugboatEng
TugboatEng
Livelee
  • Locked
  • Question Question
IVECO DAILY 2008 NON START -DASH LIT UP LIKE A CHRISTMAS TREE EVEN WITH IGNITION OFF
Replies
4
Views
1K
MadisonCameron
MadisonCameron
Cuocomponents
  • Locked
  • Question Question
a device that realizes the function of an ideal diode/OR-ing controller
Replies
3
Views
972
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top