Can anyone explain to me what the differences are between standard metric grade 10.9 bolts and bolts marked as "10.9 HV"? I found the EN 14399 standard that seems to suggest that these fasteners are designed for "preloaded joints", but that makes no sense to me because all bolted joints are preloaded to some degree.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
HV bolts nuts and washers
- Thread starter 67bonnie
- Start date
Yes, EN 14399 is the correct set of documents. Those standards identify requirements beyond basic composition and mechanical properties. Here is a good overview document:
The reason that "preloaded joints" is identified is because for large structures (buildings, bridges, etc.), it is common to have joints that are just snug tight (little preload), for example.
The reason that "preloaded joints" is identified is because for large structures (buildings, bridges, etc.), it is common to have joints that are just snug tight (little preload), for example.
- Status
Similar threads
- Locked
- Question
- Question