Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

http://www.eng-tips.com/viewthread.cfm?qid=339995

Status
Not open for further replies.

nhernandez

Mechanical
Joined
May 19, 2016
Messages
2
Location
US
thread1183-339995

Please refer to the above thread...I am still confused on how to set a virtual plane with an angle of inclination to yield correct results. I keep getting a results that appears the plate will deform but parallel to the face not to the virtual wall.

Any thought would be much appreciated. Thanks!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top