Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

HP Flare and Flare Header

Status
Not open for further replies.
Patel85

Patel85

Mechanical
Joined
Apr 4, 2015
Messages
8
Location
AE
Dear All,

As I am new for flare package, Please help to understand the basic Concept.

1) What is HP Flare and LP Flare
2) In my case, Datasheet shows allowable Pressure drop across the Flare tip (Sonic Type) and Seal is 4.5 Bar and Flare Header Operating Pressure is 0.1 bar. How it is possible.

Regards,

VK (Mechanical)
 
Status
Not open for further replies.

Similar threads

Hasab
  • Locked
  • Question Question
Flare header back pressure change
Replies
7
Views
978
Hasab
Hasab
Pavan Kumar
  • Question Question
PSV Inlet and Outlet Pressure Drop Calculation Question
2
Replies
32
Views
35K
Snickster
Snickster
TiCl4
  • Question Question
Friedel's Model (two-phase) and Noise Attenuation Questions
Replies
13
Views
19K
pierreick
pierreick
Vivaldi M. Smith
  • Locked
  • Question Question
Rule of thumb for determining how much purge gas or sweet gas need to maintain flare header pressure
2
Replies
21
Views
3K
georgeverghese
georgeverghese
Pavan Kumar
  • Question Question
Flame Arrestors on Natural Gas and Oxygen Vent Lines
Replies
7
Views
12K
shvet
shvet

Part and Inventory Search

Sponsor

Back
Top