Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

how to tell the parison to stop inflating upon contacting the mould in ANSYS Polyflow blow-moulding

Status
Not open for further replies.
andradesilva

andradesilva

Materials
Joined
Jun 20, 2017
Messages
125
Location
PT
Hi,

I am running a blow-moulding simulation in ANSYS workbench via the Polyflow module. I am inflating a bottle. I can solve the model and obtain results. However, the parison should stop inflating the contacting zones when it contacts the bottle (mould). How can I setup the simulation in a way that the parison stops inflating upon contact with the mould? I currently have the parison inflating a lot past the geometric limits of the bottle.


Thanks in advance,
Best regards,
 
Status
Not open for further replies.

Similar threads

X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X
M
  • Locked
  • Question Question
ANSYS Mechanical Scripting: how to delete an existing heatflux?
Replies
0
Views
822
MihailW
M
H
  • Locked
  • Question Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
3K
karachun
karachun
md_salem
  • Locked
  • Question Question
how to do share topology in the design modeler in Ansys Workbench
Replies
1
Views
925
Stick.
Stick.
O
  • Locked
  • Question Question
ansys civata
Replies
0
Views
2K
oktaeng1
O

Part and Inventory Search

Sponsor

Back
Top