Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

how to merge part of surface in hypermesh

Status
Not open for further replies.
zhanshenjing

zhanshenjing

Automotive
Nov 10, 2012
19
Hi everyone, I have two solid parts in hypermesh, they have a common face, but this common face is only part of each surface, is it possible to only merge part of surface, not whole surface?
 
Status
Not open for further replies.

Similar threads

Gardenfence
  • Locked
  • Question
CBUSH coincident nodes in hypermesh?
Replies
1
Views
2K
SWComposites
SWComposites
F
  • Question
How to Integrating the shear stress of the cross sectional area to find the moment M? 1
Replies
9
Views
5K
ThomasH
ThomasH
mohamed hassan 2014
  • Locked
  • Question
Nonlinear analysis using HyperMesh with OptiStruct
Replies
0
Views
547
mohamed hassan 2014
mohamed hassan 2014
D
  • Locked
How to take pickup support
Replies
0
Views
3K
deepak1313
D
jmex
  • Locked
  • Question
Reaction force to a flat and curved surface study 2
Replies
9
Views
1K
rb1957
rb1957

Part and Inventory Search

Sponsor

Back
Top Bottom