Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to measure contact areas between surfaces
- Thread starter popsin
- Start date
CADSTUDENT
Mechanical
Hello popsin:
Normally, you would catch this in the design stage. MDT provides a way to check for interference with the AMINTERFERE command or check interference from the Analysis cascading menu in the Assembly pull-down menu or pick the Check 3D Interference button on the Assembly Modeling toolbar. Hope this helps - John
Normally, you would catch this in the design stage. MDT provides a way to check for interference with the AMINTERFERE command or check interference from the Analysis cascading menu in the Assembly pull-down menu or pick the Check 3D Interference button on the Assembly Modeling toolbar. Hope this helps - John
- Status
Similar threads
- Locked
- Question
- Locked
- Question
