Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to make a Line>?

  • Thread starter Thread starter vklvsy
  • Start date Start date
V

vklvsy

Guest
How do i make a line in solid works?
 
omg. you're kidding right.
 
Just in case you are not kidding. I remember having this kind of problems as a begginner.


You open a Sketch and use the Line command (button). If you are in a drawing , to draw lines you simply use the line command (which is active in a drawing). You must have the Sketch toolbar active, that's where the line button is.


In a Sketch, a line does not help much. You need a shape of your choice that you will extrude and cut and so on. Good luck.
 

Part and Inventory Search

Sponsor

Back
Top