Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to give the thermal conductance in Steady State Thermal Analysis in Workbench?

Status
Not open for further replies.
ghnashyam

ghnashyam

Mechanical
Joined
Nov 17, 2012
Messages
5
Location
IN
Hello everyone,
I am doing a Steady State thermal analysis of a part where there is a direct contact of the hole (Material Cast Steel)and bush (Material Bronze).I have to simulate this condition in workbench.so Pls tell me how to give the thermal conductance Boundary condition.
 
Status
Not open for further replies.

Similar threads

struclearner
  • Question Question
Modelling Tapped Bolted Joint by Line Body in ANSYS Workbench
Replies
0
Views
4K
struclearner
struclearner
Faraz1997
  • Locked
  • Question Question
How to reduce number of iterations in tabular data of transient thermal analysis
Replies
3
Views
1K
NRP99
NRP99
H
  • Locked
  • Question Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
3K
karachun
karachun
W
  • Question Question
Trying to couple a transient thermal and structural simulation but I get zero deformation and stress
Replies
0
Views
2K
weldtest12
W
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X

Part and Inventory Search

Sponsor

Back
Top