Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to generate two point clouds in 3-D scanning

Thread starter -
Start date Jul 6, 2001

Status: Not open for further replies.

Jul 6, 2001

Guest

In order to get complete 3-D shape scanned, after one 180 degrees rotation, part has to be leaned one or other side (~30-60 degrees), so the scanner can get very top and very bottom images of the part.
Queston is how to generate two recieved point-couds in to one, and get complete image of the scanned part?