Kesavan Mani
Mechanical
Hello,
While creating the .SVG file in Solidworks composer, the small level parts like (Bolt, Nut and Washer etc...,) cannot be viewed properly in online views of Dynamic content.( paper space : view port ratio : width and height =297mm)
Is there any possibility of viewing each component in zoomed view when the cursor is placed over the component (or) BOM table in final .SVG output file?
Sample output format video attached in this thread.
Thanks in advance.
Regards,
Kesavan M
While creating the .SVG file in Solidworks composer, the small level parts like (Bolt, Nut and Washer etc...,) cannot be viewed properly in online views of Dynamic content.( paper space : view port ratio : width and height =297mm)
Is there any possibility of viewing each component in zoomed view when the cursor is placed over the component (or) BOM table in final .SVG output file?
Sample output format video attached in this thread.
Thanks in advance.
Regards,
Kesavan M