Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to create .dat files for MARKATOR Oscillating Dot Pin Machine

Status
Not open for further replies.
vava1

vava1

Mechanical
Joined
Jul 25, 2008
Messages
30
Location
US
Hello, I understand that .dat files are needed to create tool paths for MARKATOR oscillating dot pin machines. I would like to know if anyone knows how to do this. Thank you very much.
 
Sort by date Sort by votes
Yes, that would make sense. Technical support has not responded. Thanks.
 
Upvote 0 Downvote
pick up that device called a phone :)
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

D
  • Locked
  • Question Question
identifying and using AP242 STEP files
Replies
2
Views
3K
dtimberlake
D
PWolfy
  • Locked
  • Question Question
Replacement for ForceEffect, looking for software to create Free Body Diagram and Froce Analysis
Replies
4
Views
2K
FEA way
FEA way
bonbon83
  • Locked
  • Question Question
how to make opening in tubular member in IdeaStatica
Replies
1
Views
352
Basit Shafi
Basit Shafi
YungPlantEng
  • Locked
  • Question Question
How to increase utilization of maximo?
Replies
0
Views
246
YungPlantEng
YungPlantEng
LeRepeteur
  • Locked
  • Question Question
Autodesk Fusion 360 - How to use Remote Load's in simulation to be defined by an area
Replies
0
Views
444
LeRepeteur
LeRepeteur

Part and Inventory Search

Sponsor

Back
Top