Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to create an "add-in"

Status
Not open for further replies.

Ralph2

Industrial
Joined
May 3, 2002
Messages
345
Location
CA
Can someone tell me how to add GearTec 2013 from Camnetics to Solidworks 2014 as an "Add in".. is it possible?

Thank you for your time.
 
With GearTec installed I would expect it to show up in SWX. However, you should be able to go into SWX Tools -> Add-ins (at the very bottom of the Tools menu. It should show up there and then you would just check the appropriate box for it. If it does not show up there then I suggest you contact GearTec support for their help.

- - -Updraft
 
Thanks.. but it does not show in SW as being available.. and the CAD tab is greyed out in GearTeq. I have a help request in to Camnetics..
 
Thanks all.
Problem resolved.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top