Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

HOW TO CREATE A POINT IN THE CENTRE OF THE HOLE

Status
Not open for further replies.

sajuprab

Industrial
Joined
Oct 14, 2002
Messages
11
Location
IN
HAI FRIENDS
HOW TO CREATE A POINT IN THE CENTRE OF THE HOLE
 
1. Click the Point icon (then the Point Definition dialog box will appear)
2. Use the combo to choose the "Circle center" point type
3. Select the hole that you need to create a point on.
 
What is your program version?
Kae's advise is V5 based.

If you're in V4 then do the following
1. select POINT - LIMITS - PTS
2. click ecge curve of a hole

You get three points: Center point and both end points of a curve.
 
in V4 you may not always get a center point using limits on a curve, you may need to develop a circle thru 3-points first, then do what eklunja mentions to get center point.

 
Hi,

If you run V5, you already got your point in the sketch used by the Hole feature.

Eric
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top