Is there a way to create a break line on a part in a drawing that will cut off the unwanted half of the part. I've tried creating a line and just changing it to a break line, then trimming the object lines of the part to the break line but it wouldn't highlight the object lines to trim. Any ideas? I've attached a power point to illustrate what I'm working with below.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to create a break line on a part
- Thread starter Jashe
- Start date
- Status
Similar threads
- Question