Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

how to change tracking set up in UNX 1

Status
Not open for further replies.

ramin1975

Mechanical
Joined
Dec 6, 2004
Messages
2
Location
CA
When drawing in Unigraphics,(a line for example) the first
entry (first point) can be entered in X & Y format but for the second point I have to enter length and angle, can I set up the system so that I can continue with X & Y? Thanks
 
After you enter the start point, enter another X and Y for the end point. Also, you can use the delta option to get delta offsets from the start point.
 
Thanks Cowski, I never noticed that delta option. Just when you think you know most of what the software offeres, you find something new in the simplest of commands.

Keith Young
keith.a.young@comcast.net
Walway Enterprises
UG Tool Design
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top