Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to change Default "button" when Solid Edge starts

Status
Not open for further replies.
Razerzpeed

Razerzpeed

Geotechnical
May 26, 2006
5
Whenever Solid Edge Part starts, the Default mode or button that is activated is "Protrusion" I would like it to be "sketch"

Any Ideas how to do this???
-B
 
Status
Not open for further replies.

Similar threads

jcpalekar
  • Locked
  • Question
How to handle occurrence properties of solid edge through excel sheet?
Replies
0
Views
935
jcpalekar
jcpalekar
NirVidP
  • Locked
  • Question
How to 'Create Part In Place' using vba?
Replies
0
Views
887
NirVidP
NirVidP
Abhishek H M
  • Locked
  • Question
Solid Edge
Replies
3
Views
1K
kjoiner
kjoiner
J
  • Locked
  • Question
VBA to Pull Total Surface Area and Volume for a Part of an Assembly?
Replies
0
Views
1K
jdconnel
J
Vikas4auto2019
  • Locked
  • Question
How to add bulk components in to the assembly.
Replies
0
Views
820
Vikas4auto2019
Vikas4auto2019

Part and Inventory Search

Sponsor

Back
Top Bottom