Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
how to apply displacement rate upto a certain displacement in abaqus?
- Thread starter Rajnan07
- Start date
You can do this using amplitude. Its tabular definition allows you to specify data points like this:
time1, value1
time2, value2
time3, value3
…
The amplitude values at each moment of time are multiplied by the magnitude of the boundary condition.
time1, value1
time2, value2
time3, value3
…
The amplitude values at each moment of time are multiplied by the magnitude of the boundary condition.
- Thread starter
- #3
It would be really great if you could explain lil bit considering my case (1mm/min displacement rate and 10mm displacement).
Because I tried doing that but did not work may be because of wrong input.
Also in case of using amplitude what shall I provide in the step module time increment?
Because I tried doing that but did not work may be because of wrong input.
Also in case of using amplitude what shall I provide in the step module time increment?
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question