Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How simulate in design simulation in nx 9

Status
Not open for further replies.
suyog21

suyog21

Automotive
Joined
Feb 23, 2011
Messages
50
Location
IN
12_ipnt5n.jpg


How simulate in design simulation in nx9


if pressure 20bar and vane is rotating and sliding assuming material steel.

I tried but not able to fix the vane in slot portion in simulation.

Suyog Patil
CAD Engineer
NX 7.5. 8, 8.5 9, 10 TC-9
 
Status
Not open for further replies.

Similar threads

Jashe
  • Question Question
Sketch Failure Message in NX
Replies
3
Views
2K
Jashe
Jashe
CAD2015
  • Locked
  • Question Question
NX 2212 - How to hide centerlines in 2D views.....
Replies
2
Views
2K
CAD2015
CAD2015
S
  • Question Question
Reverse Engineering Surface Modeling from STL in Siemens NX
Replies
0
Views
3K
Sennja
S
Jashe
  • Question Question
How to create Radial Section Cut on NX Drawing
Replies
5
Views
11K
SDETERS
SDETERS
hnam2003
  • Locked
  • Question Question
How to patch detail prints in NX 10
Replies
5
Views
594
Toost
Toost

Part and Inventory Search

Sponsor

Back
Top