Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How can I use connector, translator

Status
Not open for further replies.
blackcanis

blackcanis

Structural
Joined
Dec 30, 2010
Messages
1
Location
A1
I'm modeling sheet pile and I want use translator as connector but I don't know how to use translator.

I just connect two point using connector builder in interaction step.

But, I see aborted singe in job step.

Please let me know how to use translator.
 
Status
Not open for further replies.

Similar threads

B
  • Locked
  • Question Question
Can I use a static linear perturbation step in ABAQUS?
Replies
3
Views
3K
Vishakh_Rajendran
Vishakh_Rajendran
F
  • Locked
  • Question Question
How can I obtain integrals over curves and surfaces?
Replies
1
Views
1K
FEA way
FEA way
F
  • Question Question
How to determine G12 if I have E1, E2 and v12?
Replies
1
Views
339
FEA way
FEA way
jball1
  • Locked
  • Question Question
Connector Damage/Failure
Replies
6
Views
1K
jball1
jball1
A
  • Locked
  • Question Question
How can I correctly model the damping behavior in ABAQUS for unidirectional composites to achieve realistic oscillations that decay over time?
Replies
6
Views
3K
FEA way
FEA way

Part and Inventory Search

Sponsor

Back
Top