Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How can I keep the same Components in Hypermesh and Hyperview

Status
Not open for further replies.
flyforever85

flyforever85

New member
Joined
Jun 22, 2010
Messages
178
Location
US
I have a model with 66 components. When I solve it, the components become 10 and they are divided by property. This makes very difficult to select a single component for a better view.

Is there a possibility to keep the same components between hypermesh and hyperview?

Thank you
 
Status
Not open for further replies.

Similar threads

Nir_k
  • Locked
  • Question Question
How to select both the exterior and interior surfaces (All Entities) of an element when creating surfaces in Hypermesh?
Replies
0
Views
2K
Nir_k
Nir_k
Sayed Ghalleby
  • Locked
  • Question Question
Modal analysis and effective mass fraction modification
Replies
1
Views
1K
GregLocock
GregLocock
Max121
  • Locked
  • Question Question
"Exporting mesh hypermesh to ansys
Replies
0
Views
723
Max121
Max121
Beider
  • Locked
  • Question Question
Modeling HDPE with upper and lower yield points and >300% strain - RADIOSS
Replies
1
Views
726
hiper_88
hiper_88
Behdad.S
  • Locked
  • Question Question
How do separate parts that share some same nodes?
Replies
2
Views
809
Behdad.S
Behdad.S

Part and Inventory Search

Sponsor

Back
Top