blackmaddog
Structural
- Oct 13, 2008
- 42
How do you calculate (or lookup) the shear capacity of a bolt through both faces of a hollow (ungrouted) 8" CMU block?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Hollow CMU through bolt capacity 1
- Thread starter blackmaddog
- Start date
- Status
-
1
- #2
see report at:
the TEK series shows grouted design
12-3A Design of Anchor Bolts Embedded in Concrete Masonry (11-2004)
the TEK series shows grouted design
12-3A Design of Anchor Bolts Embedded in Concrete Masonry (11-2004)
- Thread starter
- #3
blackmaddog
Structural
- Oct 13, 2008
- 42
I looked through all the TEK titles and skimmed some of the anchorage reports and I didn't find any reference to un-grouted through bolts. I see this type of connection regularly in the field but don't have any idea how to define an allowable load.
Has anyone in here ever done this?
Has anyone in here ever done this?
Why dont you want to use Hilti HY 20 for hollow concrete block? The tension and shear capacities are explicitly given in a Hilti product guide. I know some are concerned about using such anchors, but I use them all the time. They have been performing just fine.
- Thread starter
- #5
blackmaddog
Structural
- Oct 13, 2008
- 42
Pyira15 - See this thread
Maybe you have something to add.
Maybe you have something to add.
- Status
Similar threads
- Locked
- Question