Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

HOLE

  • Thread starter Thread starter jojijohnson
  • Start date Start date
J

jojijohnson

Guest
how to put hole concentric to a fillet
 
give me some answer
 
Create a Datum axis using round surface and then place hole using that axis by co-axial type.


Then It would be parameteric.
 
You must log in or register to reply here.

Similar threads

engineeringspread
  • Locked
  • Question Question
Single Hole Pattern from sketch
Replies
1
Views
691
DesEng1986
DesEng1986
Yit77
  • Locked
  • Question Question
Creo Parametric 6 - How to disable or stop hole tabel auto update?
Replies
3
Views
538
3DDave
3DDave
TiagoFigueiredo
  • Locked
  • Question Question
vb find specific face and axis of a hole
Replies
0
Views
204
TiagoFigueiredo
TiagoFigueiredo
S
Creo 2.0 Hole tool
Replies
3
Views
7K
saspinall
S
T
Reset Hole Note
Replies
0
Views
3K
TMPENG
T

Part and Inventory Search

Sponsor

Back
Top