I there any way to create a favorite drilled hole that will give me say an H7 tolerance with the drilled hole for a dowel pin. I have tried editing the 3d sketch dimension and adding the H7 or what ever and it works, I tried going in and editing the feature in the hole wizard, but it does not pick up the fit for future holes.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Hole wizard fit call outs.
- Thread starter tap90291
- Start date
Sounds like you need to add a custom Database to use for any speical holes you want to make - See this link on how make a new Database - - Remember though if you make new (customized) threaded holes you will need to add them to the Thread Data at the end of your new Database.
Regards,
Scott Baugh, CSWP![[pc2]](/data/assets/smilies/pc2.gif "[pc2] [pc2]")
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376
Regards,
Scott Baugh, CSWP
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376
- Status
Similar threads
- Question
- Locked
- Question