Hole Wizard - Disable does not work when modifying hole

[mmlentz]

We've begun to use a custom hole wizard database, intended to simplify the selection process (ie, picking the correct thread for an M10 tap). We copied the ANSI metric database and disabled holes as appropriate. This works for a new hole, but when editing an existing hole, ALL of the disabled holes are shown, even with the custom standard selected. Any ideas?

Thanks,
Mike
SW 2007 SP3.0

 

[CorBlimeyLimey]

SP3.1 is now available and it has a couple of SPRs affecting the Hole Wizard. Maybe it will fix the problem.


SW07-SP3

 

[brengine]

That has a SPR out on at at least as of SW2007 sp2. It was that way in SW2006 too. SW2007 sp3.1 had other bugs in it (I don't specifically remember checking for the one you described) so we are waiting to evaluate the next release.

Ken

 

[mmlentz]

Thanks Ken, I had looked but couldn't find an SPR. DO you have the number?

Thanks,
Mike