Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hole thread in drafting 1

Status
Not open for further replies.
In the view properties you have the "thread" option selected. Your hole depth is deeper than your thread depth. That line indicates the boundary between the tapped part of the hole and the drilled part of the hole.
 
Thread option is selected of course,I have more threaded sections that are fine but this one is not.
 
Go to your Hole Definition / Thread Definition and in Bottom Type select Support Depth.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top