Hole Table

[gopens]

We are currntly running SW 2008 SP2.0. The problem we are having is with a hole table. The hole table does not want to assign numbers to hidden holes and holes on multiple surfaces. The hole table also picks arcs which are not generated by the hole wizzard. All the holes were on the piece were placed with the hole wizzard.

Any ideas?

 

[AnnaWood]

Don't select faces. Individually select hole edges. Or you can select a combinations of faces and holes edges. Technique depends on the part.

Can you post a typical offending part and drawing with a hole chart applied? I will see if I can give you some ideas of techniques to use.

Cheers,

Anna Wood
SW2008 SP5.0, Windows Vista SP1
IBM ThinkPad T61p, T7800, FX570M, 4 gigs of RAM

http://www.solidmuse.com

http://www.phxswug.com

 

[gopens]

You are right about picking faces. I will email you the file. We need to put the hole table on the second sheet. It looks like the holes missing from the table are the ones from the back side of the part. Maybe I have to run a seperate table for the back side.

Thanks,

Kevin