HOLE SERIES ISSUE

[mikestl]

I am trying to start a Hole Series in an assembly and unable to select existing holes that were created using Hole Wizard using a 3d sketch (holes are on different different planes on one part). Hole series is not recognizing these holes.

Is Hole Series not able to use existing holes that were created in 3d sketched Hole Wizard holes?

Mike J

 

[Nella95]

Yeah, you can use a sketch not created in the hole wizard. View 'sketches.' However, you might have to create a sketch and 'convert entities' in the sketch tool to make them show up on a separate sketch.

SW Premium 2011
64 bit SP4.0
Intel Xenon X5650 @2.67GHz
2.66 GHz 11.9 GB of RAM