Hole Callout, Hole nog selectable ?

[Lars1978]

Hi ALL,

I've tried to make a hole callout on the attached .prt. It seems i'm doing something wrong.

I've treid the M6 holes arround the square cutout but i can't select them.

Does anyone have any solution ?

NX10.0.3.5, Windows 7,
Lars.

 

[Toost]

Can you describe, in detail, how/what you did?

I tried it Inside the model file, on the existing drawing.
Works fine.
I also tried to create a new , separate, drawing , where this model is displayed.
Works fine.

When the view exists on the drawing sheet.:
in the Dimension group on the Home tab. ( I hate the ribbon UI, this description on where and how to find a button...idiotic)
Select the "Radial" dimenssion type, In the dialog change the method from "inferred" to "Hole callout", then select.


Regards,
Tomas