C
carbonmike
Guest
Hello,
I working on shell model with several parallel beams which are very close to each other. I didnt had any problem with them before, several month of simulations, always worked, meshed okey. From some point of modeling they dont work anymore. There is message ,,highlighted beams are coincident,,. When I open older file it works there, with same gaps, same dimensions, same beam parameters and releases. So this issue is probably cause by some setup. Mesher decide what is too close and then think that they are coincident. Do you know about any setup that can influence this?
Thanks.
Mike
I working on shell model with several parallel beams which are very close to each other. I didnt had any problem with them before, several month of simulations, always worked, meshed okey. From some point of modeling they dont work anymore. There is message ,,highlighted beams are coincident,,. When I open older file it works there, with same gaps, same dimensions, same beam parameters and releases. So this issue is probably cause by some setup. Mesher decide what is too close and then think that they are coincident. Do you know about any setup that can influence this?
Thanks.
Mike
