Hidden thread in drafting NX8.5

[aleksandar81]

My thread is hidden with full circle line, upper case, so every time I have to hide that circle so I can see the thread.How can I change this?

 

[NutAce]

Turn of the Start/End Chamfer in the Threaded Hole Feature...The edge of that is overlapping the Thread circle...

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5

HP Zbook15
Intel(R) Core(TM) i7-4800MQ
CPU @ 2.70 GHz Win7 64b
Nvidia K1100M 2048 MB DDR5

 

[aleksandar81]

Thank you it works. As you know start-end chamfer on threaded hole is necessary,so I would like them to have on model,because if I decide to use threaded hole section in drafting, I need to show that chamfer.Is it possible to customize and turn off/hide chamfer when using view projection.

 

[NutAce]

You can hide them in the view using "View Dependent Edit"...
Or make them a bit bigger such that they no longer cover the thread curve..

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5

HP Zbook15
Intel(R) Core(TM) i7-4800MQ
CPU @ 2.70 GHz Win7 64b
Nvidia K1100M 2048 MB DDR5

 

[aleksandar81]