Hi
I would like to know if someone has experience or has already used dynamic simulation to determine relief rate to design pressure safety valves.
The traditional methodology is based on simplified calculation, but this procedure can lead to over designing relief headers and flare systems. So, I think that dynamic simutation should be a good tool to improve relief rate estimation.
Thanks
Neyde
I would like to know if someone has experience or has already used dynamic simulation to determine relief rate to design pressure safety valves.
The traditional methodology is based on simplified calculation, but this procedure can lead to over designing relief headers and flare systems. So, I think that dynamic simutation should be a good tool to improve relief rate estimation.
Thanks
Neyde
) Regards, 