Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hi everyone, please assist. What is

Status
Not open for further replies.

Ohuti

Mechanical
Joined
Sep 12, 2024
Messages
3
Location
ZA
Hi everyone, please assist. What is the typical thermal oil volume flow rate for particleboard pressing?
 
Just a little bit of additional info might assist, but please don't over do it and confuse everyone.

It is a capital mistake to theorise before one has data. Insensibly one begins to twist facts to suit theories, instead of theories to suit facts. (Sherlock Holmes - A Scandal in Bohemia.)
 
Is this a repeat of your other post?

Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top