Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

HELP REQUIRED

  • Thread starter Thread starter Adnan
  • Start date Start date
A

Adnan

Guest
Hello Dear Friends

I am facing a problem. In Creo 3.0 when I am opening an imported Geometry (Catia File). It is an automotive sheet metal part, only one side part surface received, I needed to add thickness on it and converting in to sheet metal environment and then required un blanking for designing blanking tool.

But part thickness is not being created.

I have just saw this Creo users Forum on face book. I shall be very thankful if anybody could resolved my problem.

Thanking you
 

Part and Inventory Search

Sponsor

Back
Top