HELP pls Parts not updating from assemblies

[RobPosteng]

I am getting crazy over the fact that;
- if i add a hole wizard feature on a part form within an assembly, it does not show on the part when I open this. Strange thing is that i.e. a cut-extrude done the same way, does properly show... as it should do!

Aanyone can help please?

THX

 

[Updraft]

Do you happen to have configurations in your part? If so it could be that the config you are changing in the part file is not the same as the one referenced in the assembly.

- - -Updraft

 

[NL8]

Check the propagation setting on both the hole wizard and the cut. Look in the feature tree of the part after the hole is added. Could be suppressed. Alternately consider using a Hole series at the assembly level, that automatically propagates.

Joe Hasik,
CSWP/SMTL/MTLS
SW 10 x64, SP 3.0
Dell T3400
Intel Core2 Quad
Q6700 2.66 GHz
3.93 GB RAM
NVIDIA Quadro FX 4600

 

[RobPosteng]

Ok, THX!!