Help needed using lbs/minute per square inch of shank

[anilomah3]

Fist of all, thank you for viewing this thread and for any help that you may provide.

I need to figure out a load rate for a test, can you help by providing me with the formula? The calculation is as follows:

The test has to be done at rates producing 100,000 lbs/minute per square inch of fastener shank area. The fastener shank diameter is .132, area is 0.013685.

Again, thank you for your help.

 

[SnTMan]

100,000 lbs/minute per square inch x 0.013685 sq in = 1368.5 lb / min.

Regards,

Mike

 

[anilomah3]

Thank you Mike, I feel so silly right now.

Have a great day.

 

[SnTMan]

Yeah, I never have days like that