xplanck
Aerospace
- Aug 3, 2011
- 3
Hi,
I am relatively new to Ansys APDL.
My question is: I have designed a Solid185 plate with one Piezoelectric patch (it is Solid5) on it. Now, as Solids consists of more nodes (8) I have to switch over to Shell181. Now my problem is, when I find transient response from Solid and from Shell, I want to have same response output from both of them.
Can any one please explain, if any validations I have to do, any specific detail which might help me solving this problem...
Thanks a lot...
I am relatively new to Ansys APDL.
My question is: I have designed a Solid185 plate with one Piezoelectric patch (it is Solid5) on it. Now, as Solids consists of more nodes (8) I have to switch over to Shell181. Now my problem is, when I find transient response from Solid and from Shell, I want to have same response output from both of them.
Can any one please explain, if any validations I have to do, any specific detail which might help me solving this problem...
Thanks a lot...