Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hello, I am running a single-poi

Status
Not open for further replies.
gespo91

gespo91

Aerospace
Joined
Aug 30, 2021
Messages
1
Location
GB
Hello,

I am running a single-point response spectrum analysis using ansys R20, and the NRL-sum as combination method:

Cattura_lbl80q.jpg


Is there any way in ansys to plot the stesses (Ri) related to the N modal frequency taken in consideration?


Thank you
 
Status
Not open for further replies.

Similar threads

W
  • Question Question
Trying to couple a transient thermal and structural simulation but I get zero deformation and stress
Replies
0
Views
2K
weldtest12
W
md_salem
  • Locked
  • Question Question
Hello everyone, How to define an e
Replies
0
Views
200
md_salem
md_salem
O
  • Question Question
Simulation of a screw connexion
Replies
1
Views
4K
dgeesaman
dgeesaman
andradesilva
  • Locked
  • Question Question
I am not able to see fracture of the specimen in explicit dynamics in ANSYS Workbench 2023 R1
Replies
0
Views
382
andradesilva
andradesilva
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H

Part and Inventory Search

Sponsor

Back
Top