Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hello, I am running a single-poi

Status
Not open for further replies.
gespo91

gespo91

Aerospace
Aug 30, 2021
1
Hello,

I am running a single-point response spectrum analysis using ansys R20, and the NRL-sum as combination method:

Cattura_lbl80q.jpg


Is there any way in ansys to plot the stesses (Ri) related to the N modal frequency taken in consideration?


Thank you
 
Status
Not open for further replies.

Similar threads

W
  • Question
Trying to couple a transient thermal and structural simulation but I get zero deformation and stress
Replies
0
Views
1K
weldtest12
W
md_salem
  • Locked
  • Question
Hello everyone, How to define an e
Replies
0
Views
147
md_salem
md_salem
O
  • Question
Simulation of a screw connexion
Replies
1
Views
3K
dgeesaman
dgeesaman
andradesilva
  • Locked
  • Question
I am not able to see fracture of the specimen in explicit dynamics in ANSYS Workbench 2023 R1
Replies
0
Views
284
andradesilva
andradesilva
H
  • Locked
  • Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H

Part and Inventory Search

Sponsor

Back
Top Bottom