Hello!
I´m having some problem with component arrays in Nx. I have assembled a pin and made an array out of it. In the assembly navigator the components appear to be constrained to satisfiably, see picture 1! When entering assembly mode again I am free to move the arrayed components although they appear to be fully constrained in the assembly navigator, see picture 2!
This is rather frustrating since it affects almost all arrayed components thus making it very time consumable.
What might be the problem?
Best regards
/Martin
I´m having some problem with component arrays in Nx. I have assembled a pin and made an array out of it. In the assembly navigator the components appear to be constrained to satisfiably, see picture 1! When entering assembly mode again I am free to move the arrayed components although they appear to be fully constrained in the assembly navigator, see picture 2!
This is rather frustrating since it affects almost all arrayed components thus making it very time consumable.
What might be the problem?
Best regards
/Martin